Page 1 of 1

Verifying Nacelle Overheat Detector

Unread postPosted: 20 Mar 2018, 08:15
by xf14
Hi all. Would like to seek advice on for C130H Nacelle Overheat detectors, is insulation check a good preventive measure for impending failures? If anyone is practicing such method, anyone have data to share on the limits? Thanks!

Re: Verifying Nacelle Overheat Detector

Unread postPosted: 22 Mar 2018, 23:21
by wbh
This may be a Time Change item , check your -6

Re: Verifying Nacelle Overheat Detector

Unread postPosted: 23 Mar 2018, 02:58
by xf14
Negative for my -6. Would be nice if anyone can share their experiences. =)

Re: Verifying Nacelle Overheat Detector

Unread postPosted: 25 Jan 2019, 13:46
by evan.st.cyr
xf14 wrote:Hi all. Would like to seek advice on for C130H Nacelle Overheat detectors, is insulation check a good preventive measure for impending failures? If anyone is practicing such method, anyone have data to share on the limits? Thanks!


Just to clarify, are you asking if we test detectors on a routine basis post installation?